To qualify for an incentive, HVAC equipment must:

• Be used for ambient cooling only
• Meet or exceed the minimum efficiency rating required for the equipment type and cooling capacity
• Be installed in a facility owned by a commercial or industrial retail customer of Potomac Edison
• Meet additional technical requirements outlined in the application
   

Flat-rate-per-unit or per-ton capacity incentives are available for:

• Air conditioners
• Chillers
• Other HVAC equipment
• Heat pumps
• Packaged terminal air conditioner (PTAC) / Packaged terminal heat pump (PTHP)
• VFDs pre‐approval

VIEW INCENTIVES

All HVAC incentive applications received by the Program Administrator will require pre-approval before the purchase and installation of equipment.

To qualify for HVAC incentives, equipment must have been purchased and installed after January 1, 2024, and after receipt of a formal pre-approval letter from the Program Administrator.

Step 1

Register as a customer or a Program Ally using the online application portal. Once you’ve registered, you can create and submit a rebate application. You will need to upload the following required documents to submit the application for pre-approval:

1. W-9 tax form for who is receiving the rebate check, dated within the last two years and wet signed.
2. Potomac Edison electric bill to confirm account number and service address, dated within the last three months. If desired, the participant may obscure all cost- and rebate-related information.
3. Cost estimate breaking out the equipment cost and labor cost. Must include model number, quantity and unit cost.
4. Savings calculator workbook.
5. Manufacturers’ specification (cut) sheets for the proposed equipment. Please highlight all relevant information, such as the equipment efficiency ratings.
6. A DLC or ENERGY STAR® listing, if applicable.

Step 2 

We will review your application to ensure eligibility and, if your application is approved, will send an Incentive Offer Letter via email. All incentive offers are contingent upon eligibility and program funding. Before proceeding with construction, please verify your acceptance of this incentive and intent to move forward with the project. Upload the acknowledged Offer Acceptance to the application through the Offers tab in the portal.

Step 3

Once the project is complete, the participant should review the approved application for any changes to the project that occurred during installation and make any needed corrections. To complete the application, you will need to log in to the portal and upload the following documentation for final review:

1. Invoice(s), breaking out the equipment cost and the labor cost. Must include the model number, quantity and unit cost.
2. Incentive Payment Request Form (the last page of the Offer Letter).
3. Letter of Attestation, must be wet signed.
4. Incentive Request Form, when rebate check is going to anyone other than the customer. Must be wet signed.
5. Manufacturers’ specification (cut) sheets for any additional equipment installed.
6. Revised calculator workbook, if scope of work has changed.

 Apply online or contact us at 855-801-5803 for assistance.

APPLY ONLINE